Home > VERIS > Power Meter Accessories > Veris H8932 Network Display

Veris H8932 Network Display

Your Price: $811.00

Retail Price:$865.47

You Save:$54.47(6%)

Back Order.

Part Number:H8932

You need to be a registered customer to order this product. Please Login to your account or click here to Register.

The H8932 serves as a display for Modbus data. The product sits in series between downstream metering devices and the upstream master, providing a display of the data passing through it. Registers of the H8238, H8035, H8036, E50Cx and E51Cx energy monitors can be viewed. The E30 and E31 meters are also supported, but the H8932 only presents a subset of the most important data points measured. While the H8932 is available with no box for fast mounting to a panel.

Pass-through communications to other Modbus devices
Multi-color LED - shows alarm status at a glance
Large LCD - 1 x 4 in backlit LCD with adjustable brightness control for easy viewing
Monitor a variety of Veris power transducers from a single location
Easy keyboard setup
Other Modbus devices must respond to the "report slave ID" command (11 hr) to allow pass-through communications from upstream network
2-position Euro-style pluggable connector (maximum wire size 12 ga) AC power termination
Communication format - 8 data bits, 1 start bit, 1 stop bit
1/4 load transceivers, duplex is UI-selectable 2 or 4-wire, 5-position euro-style pluggable connector RS-485
DCE, no handshaking, DB-9 connection, pin 2: transmitted data from display, pin 3: received data to display, pin 5: ground RS-232 (upstream only)
Four (meter, up, down, select) number/function
Contact closure or pull-to-ground (10 mA maximum) remote alarm
Optical to 2500 VAC isolation remote alarm
UI-selectable NO or NC sense remote alarm
1 x 4 in visible area, 2 lines x 16 characters per line LCD
Green, UI-adjustable brightness in 10-steps backlight
Green = normal operation, yellow = warning, red = alarm status (Tri-Color LED)